It’s fairly labor-intensive to change out eave stripping on a home but nowhere near as much work as sanding, priming, and painting rusty metal. Finally, the tricky part is nailing down the new strip while holding up the shingles. The new stripping is slipped in over the roofing felt, but under the shingles. The shingles along the lower edge of the roof are gently lifted up, so as not to damage them, and then a flat pry bar is used to remove the nails holding the eave strip to the decking. Now, generally, it’s replaced at the same time your shingles are replaced, but really it’s fairly easy to replace it anytime. And it won’t need any type of painting, just a little bit of cleaning from time to time. They are also used to direct water into a gutter, for example. Now, one alternative is to replace it with this type of metal, which is a vinyl-coated aluminum which won’t rust. Drip edge material is designed to steer water away from the edge of a building structure, protecting its rake and fascia board. But without proper maintenance, it can become very unsightly with all the rust spots that can form. Now, many homes will have eave stripping made from galvanized metal, which is designed to keep it from rusting. Miter the end of the gable peak eave strip so it’s plumb.ĭanny Lipford: Everybody knows how important your roof is to protect your home from the weather, but you might not realize how important this little metal strip is to your overall roof system.Cut and bend the top end of the matching gable eave strip so it extends over the roof peak by at least 1″ and overlaps the matching gable eave strip.At the ridge run one gable eave strip even with the roof peak.Overlap higher gable eave strips over the lower ones by at least 1”.Cut and bend the end of the gable eave strip to cover the gap between it and the lower eave strip.Install the gable eave strips over the felt underlayment and on top of the lower eave strips.Cut the last piece on the lower eave flush with the roof decking on the other end.Overlap the other pieces of eave strip by at least 1” and nail them in place.Lift up roof shingles, and nail the eave strip in place with galvanized roofing nails.Align one end of the lower eave strip even with the edge of the roof decking.Install the eave strips on the lower roof edges first, with the eave strips under the shingles and felt underlayment.Meanwhile, gutter aprons usually cost between 3 and 10 per linear foot. L-shaped drip edges usually cost between 3 and 10 per linear foot, while T-shaped drip edges cost between 10 and 15 per linear foot. Lighted Magnifying Glass That Stays Put Drip edges cost between 3 and 15 per linear foot, depending on the style.Best Lawn Care Service for Service Dogs Yorks prefabricated Stainless Steel Inside and Outside Drip Edge Corners are recommended with all of Yorks flashing products.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |